U.S. Pat # Des 411,440

This is our most popular style of highway pegs. Using our patented Magnum Quick Clamp, they are a snap to install and provide long-haul comfort. There are several styles of footpegs to choose from with various size clamps to accommodate most common engine guard diameters.

These can be installed on any round tubing (frames or engine guards), but it is important to keep in mind that the footpeg itself will end up perpendicular to the bar to which it is mounted. If your engine guard is angled in such a way so that the peg will not be level once installed, check out our right angle mounts or P/N 8008A.

Helpful Hint: If you are unsure of the diameter of the tubing on which you'd like to install the highway pegs and don't have a dial at your disposal, here is an easy way to figure it out. You'll need a piece of heavy paper or cardboard, a ruler, a pencil, and a scissors. Use the pencil and ruler to make to marks on the edge of the paper 1" apart. Take the scissors and cut lines perpendicular to the edge of the paper at the marks you just made. Fold the resulting flap of paper out of the way. Next, take the piece of paper to the bike and check to see if the tubing will slip into the opening you've made in the edge of the paper. If the opening is too small, repeat the procedure enlarging the opening to 1-1/8", 1-1/4", 1.35", 1-1/2" until you find one that will fit.

Item A Small ISO-Pegs with 1" Diameter Clamps

Item B Large ISO-Pegs with 1" Diameter Clamps

Item C Small ISO-Pegs with 1-1/4" Diameter Clamps

Item D Large ISO-Pegs with 1-1/4" Diameter Clamps

Item E Pilot™ Pegs with 1" Diameter Clamps

Item F Pilot Pegs with 1-1/4" Diameter Clamps

Item G Dually ISO-Pegs with 1" Diameter Clamps

Item H Dually ISO-Pegs with Clevis and 1-1/8" Magnum Quick Clamps

Item I Dually ISO-Pegs with 1-1/4" Diameter Clamps