FJR1300 (03-05): The Tour Performance ® Bar Adapters by HeliBars install beneath your stock bars and raise them 1" (25mm.) By offsetting the bar remount location back, out and rotating the bolt pattern, the hand grips are repositioned 1 3/4" closer to the rider. All stock cables and hydraulic lines are retained. Includes all hardware necessary for installation. Machined Aluminum

Tour Performance ® HR Triple Clamp for the Yamaha FJR1300A / AE (US VERSION): - The forward mounting option positions the stock bars 1/2” higher and 1 1/4” back while rotating the grip angle 1 degree forward for a comfortable yet sporty feel.
- The rear mounting option positions the bars 1/2” taller and 1 3/4” closer to the rider for the greatest comfort possible.
- Re-positions the handgrips and controls closer to the rider for greatly improved long distance riding. - Greatly increased fork rigidity from thicker cross section design. Tighter steering stem- to – bore clearance, and dual 8mm fork tube pinch bolts.

- Reduced vibrations felt in the hand grips.
- All stock hydraulic lines, cables and control housing wire looms are retained and provide proper slack when bars are moved from full left to right stops.

- Two threaded holes located behind the ignition switch are provided to mount one or two ram ball mounts. Additional design provisions have been engineered into the HRT Triple Clamp design for future accessory mounting.
This is one of the most comprehensive and complete designs HeliBars has ever offered. You can enjoy performance and comfort!
•Rear Offset Handlebar Mount
•Satin Finish
•CNC Machined from Solid 6061 T6 Extrusion
•Instructions with Photos and all Hardware Included
•1 1/2 hour installation time

1. 38mm (1 ) rear offset handlebar mounts re-positions the handgrips and controls closer to the rider for greatly improved long distance riding. Stock height has been maintained for a comfortable yet sporty feel.
2. Greatly increased fork rigidity from thicker cross section design. Tighter steering stem- to - bore clearance, and dual 8mm fork tube pinch bolts.
3. Reduced vibrations felt in the hand grips.
4. All stock hydraulic lines, cables and control housing wire looms are retained and provide proper slack when bars are moved from full left to right stops.
5. Two threaded holes located behind the ignition switch are provided to mount one or two ram ball mounts. Additional design provisions have been engineered into the HRT Triple Clamp design for future accessory mounting.This is one of the most comprehensive and complete designs HeliBars has ever offered. You can enjoy performance and comfort!

1 Rear Offset Handlebar Mount
Sand-cast Finish
CNC Machined from Solid 6061 T6 Extrusion
Instructions with Photos and all Hardware Included 1 ½ hour installation time